Tundra Remote Door Lock Reprogram

If the door locks cycle twice repeat steps a and b in step 6 as the remote was not accepted.

Tundra remote door lock reprogram.

Close the driver s door. Using the door control pad located on the driver s side door press the lock and unlock buttons once again for five passes. Within 3 seconds the door locks should lock and then unlock once indicating successful programming. While there is the possibility of a pretty big electrical issue most of the problems are minor and easy to fix.

Each set represents one pass. If not start again at step 1. This is the best and easiest fix. Press the lock button by itself and hold for 2 seconds.

If you key fob no longer unlocks the doors it is time for a new battery. Insert your key into the ignition switch and put it in the run position. System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed. Repeat button procedure to program remaining remote transmitters.

Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second. Remove your key from the ignition then wait for doors to lock and then unlock twice. Press and release lock or unlock button. Turn the ignition to on and then back to off and remove the key from the ignition.

Repeat steps a and b in step 6 for each new remote. If you have done everything correctly within three seconds the door locks should lock then unlock automatically. You must complete these operations within 40 seconds.